LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 104 (Tires And Wheels) >> Repair Instructions >> Aluminum Wheel Refinishing >> General Refinishing Procedures - Removal

General Refinishing Procedures - Removal

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the wheels from the vehicle. The tires may remain mounted on the wheels.
  2. Remove the balance weights and mark their locations on the tire.
  3. Remove excess grease, etc. from the wheels with wax and grease remover.
  4. Have the wheels plastic media blasted to remove the clearcoat.
    5. IMPORTANT: MASK OFF ALL MOUNTING SURFACES, whenever a wheel is refinished. The mounting surface and the wheel nut contact surfaces must not be painted or clearcoated. Coating these surfaces could affect the wheel nut torque.
  5. Clean and mask and paint the wheels.
scientia non olet · About LEMON Manuals