LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 103 (Front Drive Axle) >> Repair Instructions >> Vent Hose Replacement (8.25 Inch Axle) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Vent Hose
    GM1690649Courtesy of GENERAL MOTORS CORP.
  1. Install the vent hose to the inner fender.
  2. Raise the vehicle.
    3. Fig 2: Locating Vent Hose & Components
    GM1689174Courtesy of GENERAL MOTORS CORP.
  3. Install the vent hose retainers to the frame.
  4. Install the vent hose to the connector.
  5. Install the front differential carrier shield, if equipped. Refer to Shield Replacement .
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals