LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 103 (Front Drive Axle) >> Repair Instructions >> Vent Hose Connector Replacement - Front Drive Axle (9.25 Inch Axle) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Vent Hose Connector
    GM847064Courtesy of GENERAL MOTORS CORP.
  1. Install the vent hose connector into the differential carrier assembly.

    Apply a small amount of sealer GM P/N 12346004 (Canadian P/N 10953480) or equivalent onto the threads.

    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Tighten the vent hose connector.

    Tighten:  Tighten the vent hose connector to 28 N.m (21 lb ft).

    3. Fig 2: View Of Vent Hose To Differential Carrier Assembly
    GM834272Courtesy of GENERAL MOTORS CORP.
  3. Connect the vent hose to the vent hose connector.
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals