LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 103 (Front Drive Axle) >> Repair Instructions >> Lubricant Replacement - Front Drive Axle >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Front Drive Axle Lubricant Drain Plug
    GM834237Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the drain plug.

    Tighten:  Tighten the drain plug to 33 N.m (24 lb ft).

  2. Fill the differential carrier assembly with axle lubricant. Use the correct fluid. Refer to Capacities - Approximate Fluid in Maintenance and Lubrication and Sealers, Adhesives, and Lubricants .
  3. Install the fill plug.

    Tighten:  Tighten the fill plug to 33 N.m (24 lb ft).

  4. Install the front differential carrier shield, if equipped. Refer to Shield Replacement .
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals