Lubricant Level Inspection - Front Drive Axle (8.25 Inch Axle)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
- Make sure the vehicle is level.
- Inspect the front axle for leaks. Repair as necessary.
- Clean the area around the front axle fill plug.
- Remove the front axle fill plug (1).
- Inspect the oil level.
Specification: The 8.25 inch axle the oil level should be between 12-16 mm (0.50-0.625 in) below the fill plug opening.
- If the level is low, add oil until the level is between 12-16 mm (0.50-0.625 in) for the 8.25 inch axle. Use the correct fluid. Refer to Sealers, Adhesives, and Lubricants .
- Install the fill plug.
Tighten: Tighten the plug to 33 N.m (24 lb ft).
- Lower the vehicle.
NOTE:
Refer to Fastener Notice
.