LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 103 (Front Drive Axle) >> Repair Instructions >> Differential Carrier Assembly - Disassemble (9.25 Inch Axle) >> Inspection Procedure

Inspection Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Perform the following before disassembling the axle:

  1. Remove the fill plug from the axle.
  2. Remove the drain plug from the axle.
  3. Drain the axle lubricant.
  4. Inspect the oil and the case for metal chips.

    Determine the source of the metal chips, such as a broken gear or bearing cage.

  5. Check the ring gear backlash. Refer to Backlash Inspection and Adjustment .

This information can be used in order to determine the cause of the axle problem. The information will also help when setting up and preloading the differential case.

Determine the cause of the axle problem before disassembly, if possible.

scientia non olet · About LEMON Manuals