LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 103 (Front Drive Axle) >> Repair Instructions >> Clutch Shaft Bearing Replacement - Front Drive Axle >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the inner axle shaft and housing assembly. Refer to Inner Shaft and/or Housing Replacement - Front Drive Axle (8.25 F4WD Axle)  or Inner Shaft and/or Housing Replacement - Front Drive Axle (8.25 S4WD and 9.25 Axles) .
  2. Remove the clutch shaft from the differential carrier assembly.
    3. Fig 1: Removing Clutch Shaft Pilot Bearing - Front Drive Axle
    GM680254Courtesy of GENERAL MOTORS CORP.
  3. Remove the clutch shaft pilot bearing using the J 34011  . See Special Tools .
scientia non olet · About LEMON Manuals