LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 103 (Front Drive Axle) >> Repair Instructions >> Bracket Replacement (25 Series) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Front Axle Mounting Bracket (25/35 Series)
    GM365933Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the bracket to the vehicle.
  2. Install the washers and the nuts to the bracket.

    Tighten:  Tighten the bracket to frame nuts to 90 N.m (67 lb ft).

  3. Install the air conditioning compressor -4.8 L, 5.3 L and 6.0 L engines. Refer to Compressor Replacement in Heating, Ventilation and Air Conditioning.
  4. Install the differential carrier assembly. Refer to Differential Carrier Assembly Replacement (1500 4WD)  or Differential Carrier Assembly Replacement (2500 4WD) .
  5. Lower the vehicle.