LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 102 (Mirror System) >> Diagnostic Information and Procedures >> Heated Mirrors Inoperative

Heated Mirrors Inoperative

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Heated Mirrors Inoperative

Step Action Yes No
Schematic Reference: Outside Rearview Mirror Schematics 
Connector End View Reference: Vehicle Access Connector End Views
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle
2 Verify that the Heated Mirrors Inoperative complaint is present.
Does the Heated Mirrors System operate as described in the Description and Operation?
Go to Testing for Intermittent Conditions and Poor Connections Go to Step 3 
3 Is the rear defogger inoperative also? Go to Defogger Inoperative - Rear Window Go to Step 4 
4
  1. Disconnect the inoperative mirror.
  2. Using a test lamp connected to ground, probe the heated mirror element supply voltage circuit.
  3. Turn ON the ignition.
  4. Place the rear defogger switch to the ON position.
Does the test lamp illuminate?
Go to Step 5  Go to Step 6 
5
  1. Turn OFF the ignition.
  2. Using a test lamp, probe between the heated mirror element supply voltage circuit and the heated mirror element ground circuit.
  3. Turn ON the ignition.
  4. Place the rear defogger switch to the ON position.
Does the test lamp illuminate?
Go to Step 8  Go to Step 7 
6 Repair the poor connection or an open in the heated mirror element supply voltage circuit. Refer to Circuit Testing and Wiring Repairs .
Did you complete the repair?
Go to Step 9  -
7 Repair the poor connection or an open in the heated mirror ground circuit. Refer to Circuit Testing and Wiring Repairs .
Did you complete the repair?
Go to Step 9  -
8 Replace the mirror face. Refer to Mirror Face Replacement .
Did you complete the repair?
Go to Step 9  -
9 Operate the system in order to verify the repair.
Did you correct the condition?
System OK Go to Step 2