LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 102 (Mirror System) >> Diagnostic Information and Procedures >> DTC B1544, B1600, or B1605 >> Conditions for Clearing the DTC

Conditions for Clearing the DTC

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

When the fault is no longer present, the door module changes the current DTC to a history DTC. The door module will clear the history DTC after 50 fault-free ignition cycles, or in response to a scan tool command.

DTC B1544, B1600, or B1605

Step Action Yes No
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle
2
  1. Turn ON the ignition, with the engine OFF.
  2. Activate the mirror switch in the up, down, left, and right positions.
Does the mirror move properly with each activation?		 Go to Testing for Intermittent Conditions and Poor Connections Go to Step 3 
3
  1. Turn OFF the ignition.
  2. Disconnect the mirror connector from the appropriate door switch.
  3. Turn ON the ignition, with the engine OFF.
  4. Probe each of the mirror motor control circuit pins at the door switch one at a time with a test lamp that is connected to a good ground.
Did the test lamp illuminate at any of the test points?		 Go to Step 7  Go to Step 4 
4
  1. Connect a test lamp between the mirror motor down control circuit pin at the door switch and a good ground.
  2. Activate the mirror switch to the down position.
Does the test lamp illuminate?		 Go to Step 5  Go to Step 8 
5
  1. Connect a test lamp between the mirror motor right control circuit pin at the door switch and a good ground.
  2. Activate the mirror switch to the right position.
Does the test lamp illuminate?		 Go to Step 6  Go to Step 8 
6
  1. Connect a test lamp between the mirror motor up/left control circuit pin at the door switch and a good ground.
  2. Activate the mirror switch to the up and left positions.
Does the test lamp illuminate?		 Go to Step 7  Go to Step 8 
7 Inspect for poor connection at the harness connector of the appropriate door switch. Refer to Testing for Intermittent Conditions and Poor Connections .
Did you find and correct the conditions?		 Go to Step 10  Go to Step 9 
8 Replace the appropriate door switch. Refer to Control Module References for replacement, setup, and programming.
Did you complete the replacement?		 Go to Step 10  -
9 Replace the mirror. Refer to Mirror Replacement - Power .
Did you complete the replacement?		 Go to Step 10  -
10
  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle within the Conditions for Running the DTC, as specified in the supporting text.
Does the DTC reset?		 Go to Step 2  System OK
scientia non olet · About LEMON Manuals