LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 101 (Battery, Charging System And Starting System) >> Repair Instructions >> Battery Negative Cable Disconnection and Connection >> Connect Procedure

Connect Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
IMPORTANT: Clean any existing corrosion from the battery terminal and the battery cable end.
    Fig 1: View Of Battery Cable Components
    GM1702504Courtesy of GENERAL MOTORS CORP.
  1. Position the negative battery cable to the battery.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the negative battery cable onto the battery terminal.
  3. Tighten the negative cable nut (1)

    Tighten:  Tighten the nut to 17 N.m (13 lb ft).

  4. Close the hood.
scientia non olet · About LEMON Manuals