LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 100 (Engine Control System & Fuel - 4.8L, 5.3L, 6.0L And 6.2L - Introduction (2 Of 2)) >> Repair Instructions >> Throttle Body Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Throttle Body Assembly
    GM1401966Courtesy of GENERAL MOTORS CORP.
  1. Install a NEW throttle body gasket to the intake manifold. Align the tab of the gasket with the notch in the manifold.
  2. NOTE: Refer to Fastener Notice .
  3. Install the throttle body (508), bolts (538), and nuts (507).

    Tighten:  Tighten the bolts/nuts to 10 N.m (89 lb in).

  4. Fig 2: View Of CPA Retainer, Engine Harness Electrical Connectors & Harness Clips
    GM1696893Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Verify that the engine wiring harness electrical connector seal for the electronic throttle control is properly installed and not damaged.
  5. Connect the engine wiring harness electrical connector (3) to the electronic throttle control.
  6. Install the air cleaner outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement .
  7. Connect a scan tool in order to test for proper throttle-opening and throttle-closing range.
  8. Operate the accelerator pedal and monitor the throttle angles. The accelerator pedal should operate freely, without binding, between a closed throttle, and a wide open throttle (WOT).
  9. Verify that the vehicle meets the following conditions:
    • The vehicle is not in a reduced engine power mode.
    • The ignition is ON.
    • The engine is OFF.
  10. Start the engine.
  11. Inspect for coolant leaks.