LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 100 (Engine Control System & Fuel - 4.8L, 5.3L, 6.0L And 6.2L - Introduction (2 Of 2)) >> Repair Instructions >> Power Brake Booster Vacuum Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Wiring Harness Electrical Connector
    GM1703744Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the chassis wiring harness electrical connector (1) from the brake booster vacuum sensor.
    2. Fig 2: View Of Brake Booster & Vacuum Sensor
    GM1703767Courtesy of GENERAL MOTORS CORP.
  2. Remove the brake booster vacuum sensor from the brake booster.
  3. Remove the brake booster vacuum sensor grommet from the brake booster.
scientia non olet · About LEMON Manuals