LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 100 (Engine Control System & Fuel - 4.8L, 5.3L, 6.0L And 6.2L - Introduction (2 Of 2)) >> Repair Instructions >> Ignition Coil Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Ignition Coil Wiring Harness Electrical Connector
    GM1707122Courtesy of GENERAL MOTORS CORP.
  1. Remove the intake manifold sight shield. Refer to Upper Intake Manifold Sight Shield Replacement .
  2. Disconnect the ignition coil wiring harness electrical connector (1) from the ignition coil.
    3. Fig 2: View Of Ignition Coil & Bracket
    GM1707124Courtesy of GENERAL MOTORS CORP.
  3. Remove the spark plug wire from the ignition coil.
    • Twist the spark plug wire boot a 1/2 turn.
    • Pull only on the boot in order to remove the wire from the ignition coil.
  4. Remove the ignition coil bolts.
  5. Remove the ignition coil from the bracket. (left side shown, right side similar).
  6. There are 2 different manufacturers for the ignition coils and coil brackets. They are as follows:
    7. Fig 3: Melco(R) & Delphi(R) Ignition Coil
    GM260177Courtesy of GENERAL MOTORS CORP.
  7. The Melco® (1) ignition coil is a square design.
  8. The Delphi® (2) ignition coil is a round design.
    9. Fig 4: Melco(R) & Delphi(R) Ignition Coil Bracket
    GM260077Courtesy of GENERAL MOTORS CORP.
  9. The Melco® ignition coil bracket (1) is a square design.
  10. The Delphi® ignition coil bracket (2) is a round design.
scientia non olet · About LEMON Manuals