LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 100 (Engine Control System & Fuel - 4.8L, 5.3L, 6.0L And 6.2L - Introduction (2 Of 2)) >> Repair Instructions >> Heated Oxygen Sensor Replacement - Bank 2 Sensor 1 (1500 Series) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: A special anti-seize compound is used on the HO2S threads. The compound consists of liquid graphite and glass beads. The graphite tends to burn away, but the glass beads remain, making the sensor easier to remove. New, or service replacement sensors already have the compound applied to the threads. If the sensor is removed from an exhaust component and if for any reason the sensor is to be reinstalled, the threads must have anti-seize compound applied before the reinstallation.
    Fig 1: View Of Catalytic Converter Assembly HO2S's
    GM1704008Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Component Fastener Tightening Notice .
  1. If reinstalling the old sensor, coat the threads with anti-seize compound GM P/N 12377953, or equivalent.
  2. Install the HO2S (3).

    Tighten:  Tighten the sensor to 42 N.m (31 lb ft).

    3. Fig 2: View Of Engine Wiring Harness Electrical Connectors, (CPA) Retainers & Engine Harness Clips
    GM1704006Courtesy of GENERAL MOTORS CORP.
  3. Connect the HO2S electrical connector to the engine wiring harness electrical connector (1).
  4. Install the CPA retainer (2).
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals