LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 100 (Engine Control System & Fuel - 4.8L, 5.3L, 6.0L And 6.2L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement (1500 SWB - 98.4L (26 gal) Tank + E85) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuel Tank Pressure Sensor
    GM1704933Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel tank. Refer to Fuel Tank Replacement (1500 LWB - 117.3L (31 gal) Tank)  or Fuel Tank Replacement (1500 LWB - 117.3L (31 gal) Tank + E85)  or Fuel Tank Replacement (1500 SWB - 98.4L (26 gal) Tank)  or Fuel Tank Replacement (1500 SWB - 98.4L (26 gal) Tank + E85)  or Fuel Tank Replacement (2500 LWB - 43.5L (11.5 gal) Tank-Rear)  or Fuel Tank Replacement (2500 LWB - 98.4L (26 gal) Tank-Front) .
  2. Disconnect the evaporative emission (EVAP) line quick connect fitting from the vent valve and reposition the line out of the way. Refer to Quick Connect Fitting Service - Plastic Collar .
  3. Using a slight rocking motion while pulling straight up, remove the fuel tank pressure sensor (1).
scientia non olet · About LEMON Manuals