Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the caps from the open end of the front fuel tank.
- Remove the caps from the fuel/EVAP lines.
- Install the fuel fill hose/pipe assembly.
- Install the fuel fill hose to the front tank.
- Connect the fuel fill hose EVAP line quick connect fitting (2) to the fuel tank line. Refer to Quick Connect Fitting Service - Plastic Collar .
- Tighten the fuel tank fill hose clamp (1) at the front tank.
Tighten: Tighten the clamps to 2.5 N.m (22 lb in).
- Install the fuel fill hose integral clamp to the crossmember.
- Install the rear axle vent hose clip to the fill pipe neck.
- Position the fill pipe ground strap (5) to the left rear lamp ground wire (4).
- Install the rear lamp ground wire (4) and ground strap (5) to the frame. Insert the lamp ground wire anti-rotation tab into the hole in the frame.
- Insert the chassis wiring harness ground bolt.
Tighten: Tighten the bolt to 9 N.m (80 lb in).
- Install the rear fuel tank. Refer to Fuel Tank Replacement (1500 LWB - 117.3L (31 gal) Tank) or Fuel Tank Replacement (1500 LWB - 117.3L (31 gal) Tank + E85) or Fuel Tank Replacement (1500 SWB - 98.4L (26 gal) Tank) or Fuel Tank Replacement (1500 SWB - 98.4L (26 gal) Tank + E85) or Fuel Tank Replacement (2500 LWB - 43.5L (11.5 gal) Tank-Rear) or Fuel Tank Replacement (2500 LWB - 98.4L (26 gal) Tank-Front) .