LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 100 (Engine Control System & Fuel - 4.8L, 5.3L, 6.0L And 6.2L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Tank Draining (Dual Tanks - Rear) >> Tools Required

Tools Required

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

J 45004  Fuel Tank Siphon Hose. See Special Tools .

    Fig 1: View Of Fuel Tank Filler Housing To Body Screws & Retainer
    GM853731Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel fill cap.
  2. Remove the fuel tank filler housing to body TORX® screws (1) and retainer (2).
  3. Fig 2: Identifying Fuel Filler Components
    GM300318Courtesy of GENERAL MOTORS CORP.
  4. Remove the fuel tank filler housing to fuel tank fill pipe screws.
  5. Remove the filler housing.
  6. Fig 3: View Of Fuel Hoses & Clamp
    GM1704321Courtesy of GENERAL MOTORS CORP.
  7. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  8. Loosen the fill hose clamp (3) at the rear tank.
  9. Remove the fill hose from the rear tank.
  10. Insert the siphon hose from the J 45004  into the fuel tank. See Special Tools .
  11. Attach the siphon hose from the J 45004  to the pump devise. See Special Tools .
  12. Using a hand or air operated pump device, drain as much fuel from the tank as possible.