LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 100 (Engine Control System & Fuel - 4.8L, 5.3L, 6.0L And 6.2L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Level Sensor Replacement (2500 - 98.4L (26 gal) Tank - Front) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuel Level Sensor Electrical Connector
    GM1705918Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel tank module. Refer to Fuel Tank Pump Module Replacement (1500 LWB - 117.3L (31 gal) Tank + E85)  or Fuel Tank Pump Module Replacement (1500 SWB - 98.4L (26 gal) Tank + E85)  or Fuel Tank Pump Module Replacement (1500 Series)  or Fuel Tank Pump Module Replacement (2500 LWB - 43.5L (11.5 gal) Tank-Rear)  or Fuel Tank Pump Module Replacement (2500 LWB - 98.4L (26 gal) Tank-Front) .
  2. Disconnect the fuel level sensor electrical connector (1) from under the module cover.
    3. Fig 2: View Of Fuel Level Sensor Retaining Clip
    GM1705920Courtesy of GENERAL MOTORS CORP.
  3. Release the fuel level sensor retaining clip (1).
  4. Slide the fuel level sensor down off of the bucket.
scientia non olet · About LEMON Manuals