LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 100 (Engine Control System & Fuel - 4.8L, 5.3L, 6.0L And 6.2L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Level Sensor Replacement (1500 Series w/E85) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuel Level Sensor Electrical Connectors
    GM1704937Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel tank module. Refer to Fuel Tank Pump Module Replacement (1500 LWB - 117.3L (31 gal) Tank + E85)  or Fuel Tank Pump Module Replacement (1500 SWB - 98.4L (26 gal) Tank + E85)  or Fuel Tank Pump Module Replacement (1500 Series)  or Fuel Tank Pump Module Replacement (2500 LWB - 43.5L (11.5 gal) Tank-Rear)  or Fuel Tank Pump Module Replacement (2500 LWB - 98.4L (26 gal) Tank-Front) .
  2. Disconnect the fuel level sensor electrical connectors (1).
    3. Fig 2: View Of Fuel Level Sensor Retainers
    GM1704939Courtesy of GENERAL MOTORS CORP.
  3. Disengage the retainers (1) and slide the fuel level sensor up.
    4. Fig 3: View of Fuel Level Sensor & Module
    GM1704941Courtesy of GENERAL MOTORS CORP.
  4. Remove the fuel level sensor from the module.
scientia non olet · About LEMON Manuals