LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 100 (Engine Control System & Fuel - 4.8L, 5.3L, 6.0L And 6.2L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Hose/Pipes Replacement - Chassis (1500 Series) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Clean all fuel and evaporative emission (EVAP) lines connections and surrounding areas prior to disconnecting the lines in order to avoid possible fuel and/or EVAP system contamination.
    Fig 1: View Of EVAP Canister Purge Tube & Quick Connect Fitting
    GM1696917Courtesy of GENERAL MOTORS CORP.
  1. Relieve the fuel system pressure. Refer to the Fuel Pressure Relief .
  2. Disconnect the engine evaporative emission (EVAP) line (1) quick connect fitting from the chassis EVAP line. Refer to Quick Connect Fitting Service - Plastic Collar .
  3. Disconnect the fuel feed line quick connect fitting (2) from the fuel rail. Refer to Quick Connect Fitting Service - Metal Collar .
  4. Cap the fuel rail and EVAP pipes.
  5. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  6. Unbolt and reposition the front propeller shaft. Refer to Front Propeller Shaft Replacement .
    7. Fig 2: View Of Fuel/Evaporative Emission Pipe & Bracket
    GM1701047Courtesy of GENERAL MOTORS CORP.
  7. Remove the fuel pipe bracket nut from the bellhousing stud.
    8. Fig 3: View Of Fuel Line Clip At Bracket
    GM1549616Courtesy of GENERAL MOTORS CORP.
  8. Remove the fuel line clip from the bracket on the automatic transmission.
  9. If equipped with 4-wheel drive (4WD), remove the fuel hose/pipe clip from the bracket on the transfer case.
    10. Fig 4: View Of EVAP Lines, Fuel Feed Lines & Fittings
    GM1704490Courtesy of GENERAL MOTORS CORP.
  10. Remove the fuel line bracket bolt (3).
  11. Disconnect the chassis EVAP line quick connect fitting (4) from the fuel tank line. Refer to Quick Connect Fitting Service - Plastic Collar .
  12. Disconnect the fuel tank fuel feed line quick connect fitting (5) from the chassis line. Refer to Quick Connect Fitting Service - Plastic Collar .
  13. Cap the fuel and EVAP lines in order to prevent possible fuel and/or EVAP system contamination.
  14. Remove the fuel/EVAP line clips from the frame and crossmember.
  15. Remove the fuel line bracket locator tab from the frame.
  16. Remove the fuel/EVAP lines from the vehicle.
scientia non olet · About LEMON Manuals