LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 100 (Engine Control System & Fuel - 4.8L, 5.3L, 6.0L And 6.2L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Hose/Pipes Assembly Replacement (1500 LWB - 117.3L (31 gal) Tank ) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuel Feed Line
    GM1704745Courtesy of GENERAL MOTORS CORP.
  1. Install the fuel feed line to the fuel tank.
  2. Remove the cap from the fuel feed port on the fuel tank module.
    3. Fig 2: View Of Fuel Feed Line Retainer & EVAP Line Clip
    GM1704744Courtesy of GENERAL MOTORS CORP.
  3. Connect the fuel feed line quick connect fitting at the fuel tank module. Refer to Quick Connect Fitting Service - Plastic Collar .
  4. Install the fuel feed line to the clip (1) and close the clip.
  5. Install the fuel feed line to the retaining feature (2) in the fuel tank.
  6. Install the fuel tank. Refer to Fuel Tank Replacement (1500 LWB - 117.3L (31 gal) Tank)  or Fuel Tank Replacement (1500 LWB - 117.3L (31 gal) Tank + E85)  or Fuel Tank Replacement (1500 SWB - 98.4L (26 gal) Tank)  or Fuel Tank Replacement (1500 SWB - 98.4L (26 gal) Tank + E85)  or Fuel Tank Replacement (2500 LWB - 43.5L (11.5 gal) Tank-Rear)  or Fuel Tank Replacement (2500 LWB - 98.4L (26 gal) Tank-Front) .
scientia non olet · About LEMON Manuals