LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 100 (Engine Control System & Fuel - 4.8L, 5.3L, 6.0L And 6.2L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Hoses/Pipes Replacement - Engine >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Clean all evaporative emission (EVAP) line connections and surrounding areas prior to disconnecting the fittings in order to avoid possible system contamination.
    Fig 1: View of EVAP Line & Canister Purge Solenoid
    GM1706143Courtesy of GENERAL MOTORS CORP.
  1. Remove the air cleaner outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement .
  2. Disconnect the EVAP line quick connect fitting at the intake manifold. Refer to Quick Connect Fitting Service - Plastic Collar .
  3. Disconnect the EVAP line quick connect fitting at the EVAP canister purge solenoid. Refer to Quick Connect Fitting Service - Plastic Collar .
scientia non olet · About LEMON Manuals