LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 100 (Engine Control System & Fuel - 4.8L, 5.3L, 6.0L And 6.2L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Hoses/Pipes Replacement - Canister/Fuel Tank (1500 SWB - 98.4L (26 gal) Tank) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuel Tank EVAP Lines
    GM1704507Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP lines to the fuel tank.
    2. Fig 2: View Of Fuel Tank Clips
    GM1704505Courtesy of GENERAL MOTORS CORP.
  2. Connect the EVAP line quick connect fittings at the fuel tank module and vent valve. Refer to Quick Connect Fitting Service - Plastic Collar .
  3. Install the EVAP lines to the fuel tank clips (1, 3, 4, and 5) and close the clips.
  4. Install the EVAP lines to the fuel tank clips (2, and 6).
    5. Fig 3: View Of Fuel Tank Shield & Retainers
    GM1704741Courtesy of GENERAL MOTORS CORP.
  5. Install the fuel tank shields (1, and 4) and retainers (2, and 3).
  6. Install the fuel tank. Refer to Fuel Tank Replacement (1500 LWB - 117.3L (31 gal) Tank)  or Fuel Tank Replacement (1500 LWB - 117.3L (31 gal) Tank + E85)  or Fuel Tank Replacement (1500 SWB - 98.4L (26 gal) Tank)  or Fuel Tank Replacement (1500 SWB - 98.4L (26 gal) Tank + E85)  or Fuel Tank Replacement (2500 LWB - 43.5L (11.5 gal) Tank-Rear)  or Fuel Tank Replacement (2500 LWB - 98.4L (26 gal) Tank-Front) .
scientia non olet · About LEMON Manuals