LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 100 (Engine Control System & Fuel - 4.8L, 5.3L, 6.0L And 6.2L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Vent Solenoid Valve Replacement (2500 Series) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of EVAP Canister Vent Solenoid Retainer
    GM1706538Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP canister vent solenoid.
  2. Slide the EVAP canister vent solenoid onto the bracket until the retainer (1) engages the clip.
  3. Connect the EVAP canister vent solenoid line quick connect fitting to the vent solenoid. Refer to Quick Connect Fitting Service - Plastic Collar .
    4. Fig 2: View Of EVAP CVS Electrical Connector & CVS Bracket
    GM1224403Courtesy of GENERAL MOTORS CORP.
  4. Connect the chassis wiring harness electrical connector (1) to the EVAP canister vent solenoid.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals