LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 100 (Engine Control System & Fuel - 4.8L, 5.3L, 6.0L And 6.2L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Vent Solenoid Valve Replacement (1500 Series) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Clean all evaporative emission (EVAP) line connections and surrounding areas prior to disconnecting, in order to avoid possible EVAP system contamination.
    Fig 1: View Of EVAP Canister Vent Solenoid Electrical Connector
    GM1706529Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Disconnect the chassis wiring harness electrical connector (1) from the EVAP canister vent solenoid.
    3. Fig 2: View Of Quick Connect Fittings
    GM1706533Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the EVAP canister vent solenoid quick connect fitting (1) from the EVAP canister. Refer to Quick Connect Fitting Service - Plastic Collar .
  4. Disconnect the fuel fill pipe EVAP line quick connect fitting (3) from the vent solenoid. Refer to Quick Connect Fitting Service - Plastic Collar .
    5. Fig 3: View Of EVAP Vanister Vent Solenoid Retainer
    GM1706536Courtesy of GENERAL MOTORS CORP.
  5. Disengage the retainer (1) securing the EVAP canister vent solenoid to the bracket.
  6. Remove the EVAP canister vent solenoid.
scientia non olet · About LEMON Manuals