LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 100 (Engine Control System & Fuel - 4.8L, 5.3L, 6.0L And 6.2L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Replacement (1500 Series) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Clean all evaporative emission (EVAP) line connections and surrounding areas prior to disconnecting, in order to avoid possible EVAP system contamination.
    Fig 1: View Of Fuel Tank EVAP Lines & Canister
    GM1704492Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the EVAP canister bracket bolts and lower the EVAP canister.
  3. Disconnect the fuel tank EVAP line quick connect fittings (1) from the EVAP canister. Refer to Quick Connect Fitting Service - Plastic Collar .
    4. Fig 2: View Of Quick Connect Fittings
    GM1706533Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the EVAP canister vent solenoid quick connecting fitting (1) from the EVAP canister. Refer to Quick Connect Fitting Service - Plastic Collar .
    5. Fig 3: View Of EVAP Canister, Bracket & Bolts
    GM1706540Courtesy of GENERAL MOTORS CORP.
  5. Remove the EVAP canister.
  6. If necessary, remove the EVAP canister to bracket bolt.
  7. If necessary, remove the EVAP canister from the bracket.
scientia non olet · About LEMON Manuals