LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 100 (Engine Control System & Fuel - 4.8L, 5.3L, 6.0L And 6.2L - Introduction (2 Of 2)) >> Repair Instructions >> Engine Control Module Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of ECM & Bracket
    GM1703439Courtesy of GENERAL MOTORS CORP.
  1. Install the bottom ECM tabs into the bracket.
  2. Push the ECM in securing the ECM to the bracket.
    3. Fig 2: View Of ECM Components
    GM1703437Courtesy of GENERAL MOTORS CORP.
  3. Position the engine wiring harness lower electrical connector and engage the retainer (3) securing the lower connector (4) to the ECM.
  4. Position the engine wiring harness upper electrical connector and engage the retainer (2) securing the upper connector (1) to the ECM.
  5. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  6. If a NEW ECM was installed, program the ECM. Refer to Control Module References .
scientia non olet · About LEMON Manuals