LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 100 (Engine Control System & Fuel - 4.8L, 5.3L, 6.0L And 6.2L - Introduction (2 Of 2)) >> Repair Instructions >> Air Cleaner Element Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Throttle Body Heater Hose & Retainers
    GM1703498Courtesy of GENERAL MOTORS CORP.
  1. Remove the air cleaner outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement .
  2. Disconnect the engine wiring harness electrical connector (2) from the mass air flow (MAF)/intake air temperature (IAT) sensor.
  3. Fig 2: View Of Air Cleaner Components
    GM1707476Courtesy of GENERAL MOTORS CORP.
  4. Loosen the air cleaner housing screws.
  5. Lift up the air cleaner housing cover.
  6. Remove the air filter element.