LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 100 (Engine Control System & Fuel - 4.8L, 5.3L, 6.0L And 6.2L - Introduction (2 Of 2)) >> Repair Instructions >> Air Cleaner Element Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Air Cleaner Components
    GM1707476Courtesy of GENERAL MOTORS CORP.
  1. Install the NEW air filter element.
  2. Install the air cleaner housing cover.
    3. NOTE: Refer to Fastener Notice .
  3. Tighten the air cleaner housing screws.

    Tighten:  Tighten the screws to 3 N.m (27 lb in).

    4. Fig 2: View Of Throttle Body Heater Hose & Retainers
    GM1703498Courtesy of GENERAL MOTORS CORP.
  4. Connect the engine harness electrical connector (2) to the MAF/IAT sensor.
  5. Install the air cleaner outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement .
scientia non olet · About LEMON Manuals