LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Rear Side Door Wiring Harness Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Route the wiring harness through the pass through hole (2), ensuring that the rubber grommet seal is fully seated.
    2. Fig 1: Rear Door Wiring Harness
    GM893297Courtesy of GENERAL MOTORS CORP.
  2. Connect the door harness to the body harness (2).
  3. Fasten the wiring harness to the door by attaching all retainers in their proper location.
  4. Connect the door lock actuator electrical connector.
  5. Connect the window motor electrical connector.
  6. Connect the speaker electrical connector.
  7. Operate all electrical door components to ensure proper operation.
  8. Install the water deflector. Refer to Rear Side Door Water Deflector Replacement .
  9. Install the door trim panel. Refer to Rear Side Door Trim Panel Replacement .
scientia non olet · About LEMON Manuals