LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Rear Side Door Auxiliary Weatherstrip Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rear Auxiliary Door Weatherstrip
    GM862186Courtesy of GENERAL MOTORS CORP.
  1. Starting at the center of the pinch-weld flange, install the weatherstrip (2) to the flange (1) and work up the top and bottom towards the ends of the weatherstrip, being careful not to stretch the weatherstrip during installation.
  2. Close the doors.
scientia non olet · About LEMON Manuals