LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Rear Door Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Rear Door Fasteners
    GM900718Courtesy of GENERAL MOTORS CORP.
  1. With an assistant, align the door to the vehicle and install the fasteners (1) that retain the door hinge halves together.
    2. NOTE: Refer to Fastener Notice .
  2. Install the fasteners that retain the door check link to the body. Refer to Door Check Link Replacement .

    Tighten:  Tighten the fasteners to 9 N.m(7 lb ft)

  3. Install the wiring harness. Refer to Rear Side Door Wiring Harness Replacement .
  4. Transfer components as necessary.
  5. Install the water deflector. Refer to Front Side Door Water Deflector Replacement .
  6. Install the door trim panel. Refer to Rear Side Door Trim Panel Replacement .
scientia non olet · About LEMON Manuals