LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Rear Compartment Liner Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Floor Liner Cargo Tie Down Loops
    GM1412532Courtesy of GENERAL MOTORS CORP.
  1. Position the floor liner to the cargo floor.
  2. NOTE: Refer to Fastener Notice .

    Install the tie down loops (2) and the bolts (1) to the liner.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  3. Reposition the midgate weatherstrip onto the pinch-weld flange at the front edge of the floor liner.
  4. Close the midgate.
  5. Close the endgate.
  6. Latch and secure the spare tire carrier.
scientia non olet · About LEMON Manuals