LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Midgate Window Weatherstrip Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Midgate Weatherstrip
    GM1412508Courtesy of GENERAL MOTORS CORP.
  1. Install the midgate weatherstrip to the pinch-weld flange. Begin at either side upper corner.
    2. NOTE: Refer to Fastener Notice .
  2. Press the weatherstrip onto the pinch-weld flange, working around the upper midgate opening down to the front edge of the floor cargo liner.

    Tighten:  Tighten both sail panel screws to 10 N.m (89 lb in).

  3. Close the midgate.
  4. Power the window to the full up position.
  5. Inspect the weatherstrip for wrinkles and correct.
scientia non olet · About LEMON Manuals