LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Midgate Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Midgate Electrical Connector
    GM1243191Courtesy of GENERAL MOTORS CORP.
  1. With the aid of an assistant, position the midgate structure (3) to the vehicle.
    2. Fig 2: Midgate Hinges
    GM1412514Courtesy of GENERAL MOTORS CORP.
  2. Install the midgate hinges. Refer to Midgate Hinge Replacement .
    3. Fig 3: Midgate Wiring Harness
    GM1412515Courtesy of GENERAL MOTORS CORP.
  3. Install the midgate electrical harness. Refer to Folding Rear Panel Harness Replacement .
  4. Install the midgate latches. Refer to Midgate Latch Replacement .
  5. Install the midgate window channels. Refer to Midgate Window Channel Replacement .
  6. Install the midgate window regulator. Refer to Midgate Window Regulator Replacement .
    7. Fig 4: Midgate Window
    GM1412518Courtesy of GENERAL MOTORS CORP.
  7. Install the midgate window. Refer to Midgate Window Replacement .
    8. Fig 5: Separating Inner Midgate
    GM1412513Courtesy of GENERAL MOTORS CORP.
  8. Install the midgate inner panel. Refer to Midgate Inner Panel Replacement .
    9. Fig 6: View Of Midgate Components
    GM1427695Courtesy of GENERAL MOTORS CORP.
  9. Install the lower center garnish molding (4). Refer to Endgate Center Molding Replacement .
  10. Install the rear folding floor trim panels. Refer to Seat Back Cover Replacement - Rear Folding .
  11. Close the midgate.
  12. Close the midgate window.
  13. Adjust the midgate window, if needed. Refer to Midgate Window Adjustment .
  14. Reposition the second row seats.
scientia non olet · About LEMON Manuals