LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Midgate Hinge Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Midgate Hinges
    GM1412514Courtesy of GENERAL MOTORS CORP.
  1. Position the hinge assembly to the midgate structure.
    2. NOTE: Refer to Fastener Notice .
  2. Install the nuts.

    Tighten:  Tighten the nuts to 25 N.m (18 lb ft).

    3. Fig 2: Midgate Hinge Alignment Pin
    GM1486511Courtesy of GENERAL MOTORS CORP.
  3. With the aid of an assistant, position the midgate hinge to the alignment pin (2) on the body.
  4. Install the nuts (1).

    Tighten:  Tighten the nuts to 50 N.m (37 lb ft).

  5. Raise and latch the midgate structure.
  6. Connect the electrical connector and secure the grommet.
    7. Fig 3: View Of Midgate Components
    GM1427695Courtesy of GENERAL MOTORS CORP.
  7. Install the lower center garnish molding (4). Refer to Endgate Center Molding Replacement .
  8. Install the hinge covers. Refer to Midgate Hinge Finish Cover Replacement .
    9. Fig 4: Midgate Inner Panel
    GM1427709Courtesy of GENERAL MOTORS CORP.
  9. Install the midgate inner panel (1). Refer to Midgate Inner Panel Replacement .
scientia non olet · About LEMON Manuals