LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Midgate Hinge Reinforcement Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Midgate Hinges & Midgate Hinge Reinforcements
    GM1033740Courtesy of GENERAL MOTORS CORP.
  1. Install the midgate hinge reinforcement plate (1) to the midgate.
    2. NOTE: Refer to Fastener Notice .
  2. Install the nuts retaining the hinge reinforcement to the midgate.

    Tighten:  Tighten the midgate hinge reinforcement nuts to 25 N.m (18 lb ft).

    Position the hinges (2) and reinforcements (1) in the position marked during removal.

  3. Install the midgate regulator assembly.
  4. Install the midgate window. Refer to Midgate Window Replacement .
  5. Raise the midgate window, ensuring the midgate window is properly aligned in the seal channel. If necessary, loosen the midgate hinge nuts and adjust the hinge reinforcements.
  6. Inspect for proper fit of the midgate to the midgate weatherstrip. If necessary, loosen the midgate hinge nuts and adjust the midgate for proper fit to the weatherstrip.
  7. Install the midgate inner panel. Refer to Midgate Inner Panel Replacement .
scientia non olet · About LEMON Manuals