LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Liftgate Wiring Harness Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the liftgate.
  2. Remove the liftgate trim panel. Refer to Liftgate Trim Panel Replacement .
  3. Disconnect the latch electrical connectors.
  4. Disconnect the lock actuator electrical connector.
  5. Disconnect the rear wiper motor electrical connector.
  6. Disconnect the rear wiper module connectors.
  7. Disconnect the rear defroster grid connectors.
  8. With a flat-bladed tool, release all the retainers attaching the wiring harness to the liftgate.
    9. Fig 1: View Of Liftgate Wiring Harness
    GM832289Courtesy of GENERAL MOTORS CORP.
  9. Note routing. Remove the wiring harness from the liftgate through the passthrough holes (1).
scientia non olet · About LEMON Manuals