LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Liftgate Wiring Harness Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Liftgate Wiring Harness
    GM832289Courtesy of GENERAL MOTORS CORP.
  1. Route wiring harness through the passthrough holes (1).
  2. Noting proper routing, attach all the retainers securing the harness to the liftgate.
  3. Connect the rear defroster grid connectors.
  4. Connect the rear wiper module connectors.
  5. Connect the rear wiper motor electrical connectors.
  6. Connect the lock actuator electrical connector.
  7. Connect the latch electrical connectors.
  8. Install the liftgate trim panel. Refer to Liftgate Trim Panel Replacement .
scientia non olet · About LEMON Manuals