LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Liftgate Wedge Replacement - Body Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Liftgate Body Side Wedge
    GM832841Courtesy of GENERAL MOTORS CORP.
  1. Align the wedge (2) to the vehicle. Note the placement of the wedge location and seal (3).
    2. NOTE: Refer to Fastener Notice .
  2. Install the fastener (1) retaining the wedge to the vehicle.

    Tighten:  Tighten the fastener to 9 N.m (7 lb ft).

scientia non olet · About LEMON Manuals