LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Liftgate Weatherstrip Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Liftgate Weatherstrip
    GM832534Courtesy of GENERAL MOTORS CORP.
  1. Starting at the top center of the liftgate, install the weatherstrip to the pinch-weld flange. Work down the right and left sides towards the bottom center. Do not stretch the weatherstrip during installation.
    2. IMPORTANT: Spooning of the liftgate may be required to properly align the weatherstrip to the trim panels.
  2. Use a rubber mallet to ensure proper seating of the weatherstrip on the pinch-weld flange (1).
  3. Close the liftgate.
scientia non olet · About LEMON Manuals