LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Liftgate Strut Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Lower & Upper Ends Of Liftgate Strut
    GM831422Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Hood Hold-Open Device Caution .
    NOTE: Apply pressure only at the end of the liftgate/hood assist rod that you are removing or attaching. Do NOT apply pressure to the middle of the rod because damage or bending will result.
  1. Open the liftgate.
  2. Support the liftgate.
  3. Carefully pry the retaining clip in order to remove the lower end of the liftgate strut (1) from the ball stud on the body.
  4. Carefully pry the retaining clip in order to remove the upper end of the liftgate strut (2) from the ball stud on the liftgate.
  5. Remove the liftgate strut from the vehicle.
  6. If needed, remove the ball stud(s).
scientia non olet · About LEMON Manuals