LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Liftgate Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Transfer components, as necessary, from liftgate being replaced to liftgate being installed.
  2. With the aid of an assistant, install the liftgate to the vehicle.
    3. Fig 1: Identifying Liftgate Hinge Bolts
    GM832253Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  3. Install the bolts (1) that retain the liftgate to the liftgate hinge.

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

  4. Install the liftgate struts. Refer to Liftgate Strut Replacement .
  5. Connect the wiper washer hose.
  6. Install the wiring harness to the liftgate. Refer to Liftgate Wiring Harness Replacement .
  7. Install the liftgate trim panel. Refer to Liftgate Trim Panel Replacement .
scientia non olet · About LEMON Manuals