LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Liftgate Latch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Electrical Connectors & Liftgate Latch
    GM831323Courtesy of GENERAL MOTORS CORP.
  1. Connect the electrical connector (2) to the latch.
  2. Connect the latch release cable by placing the cable end in the cup and securing the retainer (3) to the latch.
    3. NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  3. Install the fasteners (1) retaining the latch to the liftgate.

    Tighten:  Tighten fasteners to 25 N.m (19 lb ft).

  4. Inspect the latch for proper operation.
scientia non olet · About LEMON Manuals