LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Liftgate Hinge Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Mark the location of the liftgate hinges with a grease pencil.
  2. Remove the liftgate. Refer to High Shift Effort .
  3. Remove the garnish molding. Refer to Rear Upper Garnish Molding Replacement .
    4. Fig 1: Liftgate Hinge & Bolts
    GM832601Courtesy of GENERAL MOTORS CORP.
  4. Remove the hinge bolts (1). It may be necessary to separate the hinge from the vehicle using a flat-bladed tool.
  5. Remove the hinge (2) from the vehicle.
scientia non olet · About LEMON Manuals