LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Liftgate Hinge Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Applying Silicone RTV Sealer GM P/N 12346193 To Liftgate Hinge
    GM870099Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Ensure that all factory sealer is removed from between the hinge and the vehicle prior to installation.
  1. Apply silicone RTV sealer GM P/N 12346193 (Canadian P/N 10953536) to the entire shaded area of the hinge (1). Failure to do so will result in water and wind getting into the vehicle.
  2. Align the liftgate hinge to the location marks previously made.
    3. Fig 2: Liftgate Hinge & Bolts
    GM832601Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  3. Install the hinge bolts (1).

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

  4. Install the garnish molding. Refer to Rear Upper Garnish Molding Replacement .
  5. Install the liftgate. Refer to High Shift Effort .
scientia non olet · About LEMON Manuals