LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Hood Rear Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the hood.
    2. Fig 1: Rear Hood Seal
    GM821591Courtesy of GENERAL MOTORS CORP.
  2. Install the rear hood seal (1) by pressing the seal onto the flange (2). Ensure that the seal is fully seated.
  3. Close the hood.
scientia non olet · About LEMON Manuals