LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Hood Latch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the hood.
  2. Mark the hood latch location on the hood latch support (1) with a grease pencil.
    3. Fig 1: Hood Latch Fasteners
    GM820669Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not crimp the hood latch release cable.
  3. Remove the fasteners (2) from the latch.
  4. Disconnect the hood latch release cable from the hood latch by squeezing the hood release cable retainer (3).
  5. Remove the hood latch from the hood latch support bracket.
scientia non olet · About LEMON Manuals