LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Hood Latch Release Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the hood.
    2. Fig 1: Cable End & Hood Release Handle
    GM833078Courtesy of GENERAL MOTORS CORP.
  2. Remove the cable end (1) from the latch.
  3. Release the retainer clips that retain the hood release cable to the cowl.
  4. Open the driver side door.
  5. Remove the driver side kick up panel. Refer to Front Floor Kick-Up Panel Replacement .
    6. Fig 2: Hood Release Handle Fastener
    GM833080Courtesy of GENERAL MOTORS CORP.
  6. Remove the fastener (1) retaining the hood release handle to the vehicle.
    7. Fig 3: Cable End & Hood Release Handle
    GM833078Courtesy of GENERAL MOTORS CORP.
  7. From the driver side compartment area, pull the cable through the access hole in the cowl (2).
scientia non olet · About LEMON Manuals